Welcome to the iPodRepairSquad.com iPod Nano Gen one disassembly manual. These models are modest and fragile so make sure you use treatment once managing your unit.
Items You may Will need
- Instruments Essential ? Soft Resources - utilised to open the circumstance devoid of scratching. Offered at www.ipodrepairsquad.com ? Tiny Phillips head screwdriver - #00
Opening the Scenario
? Be confident the Maintain Change is turned on. You may see orange the moment you have the Maintain in the right place.
? Utilizing one soft device wedge it into the aspect of the iPod. It's favored to remain away from the Maintain Change and the headphone jack.
? Employing a facet to aspect movement, loosen the iPod whilst gently prying up and down. It's useful to insert two soft Resources at as soon as, Utilizing 1 to Maintain the gap open and the other to slide.
? There are a number of clips keeping the scenario in placement, so function your way about and pop 1 aspect off initial, then move forward to the leading or bottom and the situation ought to snap proper off.
Dislodging the Battery
? Utilizing a soft instrument gently pry up on the battery from the edge demonstrated. It really is held on with some adhesive so You will have to operate all around the facet as effectively.
? The moment it really is loose you really should be capable to flip the battery out but be watchful due to the fact it really is even now soldered to the logic board.
? If you're changing the battery you can possibly use the soldering strategy or the twisting approach. These might be coated in separate manuals in the foreseeable future. For now depart the battery connected.
Taking away the Logic Board
? There are 4 screws to take away as proven with the Red arrows in the photograph previously mentioned. These might be coated with tape. Be mindful not to strip the screws.
No cost Logic Board From Clips
? Be certain to use a flat screwdriver to loosen the logic board from the 4 clips proven over so You are going to have far more place to function with ahead of you move forward to the up coming phase.
Eliminating the ClickWheel Ribbon
? We have discovered the top way is to Maintain the Nano in between your thumb and very first 2 fingers. You will not have a lot area to function but it is sufficient to get a tiny flat head screwdriver in there and elevate the clip up.
? The ribbon is held in position by a connector on the logic board (see following action.)
? The black latch requirements to be flipped to the up placement as proven over and then the cable can be effortlessly eliminated. If you are keeping it like demonstrated flip the latch in the direction of your thumb.
Additional photograph of ClickWheel Connector referenced over
Getting rid of the LCD
? The LCD is taken out in the exact same way as the ClickWheel. Be certain not to harm the black clips.
? The black clips are a bit tougher to snap back again into position than they are to snap up, so we suggest Making use of a flat device so as to not place as well significantly strain on any 1 level of the black clip.
LCD is Now Free of charge
Perform in reverse order to set up the Essential part you Want. If you have issues sense Totally free to speak to us at customerservice@ipodrepairsquad.com or one-888-IPOD-Resolve
No comments:
Post a Comment